PAS-225
Drive Shaft (Lower)
1.
Loosen screw (B) and remove
locating screw (C). Pull gear case
and shield from drive shaft
housing.
2.
Pull flexible cable (D) from the
drive shaft housing, wipe clean
and re-coat with 15 ml (0.5 oz.) of
grease.
3.
Slide the flexible cable (D) back in
the drive housing. DO NOT get
dirt on the flex cable.
4.
Install the gear housing and shield
assembly.
Nylon Line Head Disassembly Instructions
Note: For normal use, Speed Feed
necessary. However, if circumstances require disassembly,
follow these instructions.
1.
Press top of locking tabs (A) on
both sides of Speed Feed
head to release cover (B) from
eyelet carrier (C).
2.
Remove cover from eyelet
carrier.
X7732274303
© 01/2020 ECHO Incorporated
®
head disassembly is not
®
C
MAINTENANCE
C
B
A
B
41