Nylon Line Head Disassembly Instructions - Echo SRM-225 Operator's Manual

SRM-225
Drive Shaft (flex cable only)
1. Loosen screw (B) and remove locating screw (C). Pull gear
case and shield from drive shaft housing.
2. Pull flexible cable (D) from the drive shaft housing, wipe
clean and re-coat with 15 ml (0.5 oz.) of grease.
3. Slide the flexible cable (D) back in the drive housing. DO
NOT get dirt on the flex cable.
4. Install the gear housing and shield assembly.

Nylon Line Head Disassembly Instructions

Note: For normal use, Speed Feed
necessary. However, if circumstances require
disassembly, follow these instructions.
1. Press top of locking tabs (A) on both sides of Speed Feed
head to release cover (B) from eyelet carrier (C).
2. Remove cover from eyelet carrier.
X7732278503
© 01/22 ECHO Incorporated
head disassembly is not
®
D
®
C
MAINTENANCE
C
B
A
B
29