Lubrication - Echo PAS-225 Operator's Manual

PAS-225VPB

Lubrication

Level 1.
Parts Required: Lithium Based Grease.
Gear Housing
1. Clean all loose debris from gear box.
2. Remove plug (A) and check level of grease.
3. Add grease if necessary. DO NOT over-fill.
Drive Shaft (flex cable models)
(Trimmer Attachment Only)
1. Loosen two (2) screws (B) and remove center locating screw (C). Pull gear box and shield from drive
shaft housing.
2. Pull flexible cable from the drive shaft housing, wipe clean and re-coat with a thin coating (15 ml [1/2 oz.])
of grease.
3. Slide the flexible cable back in the drive housing. DO NOT get dirt on the flex cable.
4. Install the gear housing and shield assembly.
Flat edge of washers (D) must be against drive shaft.
Drive Shaft Upper
1. Loosen clamping knob (A).
2. Pull locator pin (B) and rotate 1/4 turn counterclockwise to
lockout position.
3. Remove attachment.
X7722278200
© 11/2014 ECHO Inc.
MAINTENANCE
B
D
C
A
C
A
D
B
29