Cutting Tile - MK Diamond Products MK-170 Owner's Manual

MK-170 Tile Saw
MK-170 Setup for Operation
CaUTiON
1. Before connecting the MK-170 to a power supply, be sure the voltage, cycle
2. If using an extension cord, make sure the length and wire gauge correspond
3. Use an approved Ground Fault Circuit Interrupter (GFCI)
4. Do not cover the motor vents as this could lead to motor overheating.
NOTe:
In order to avoid breaker tripping, a 20-amp circuit breaker should be used.
(A)
Plug MK-170 into the GFCI (A
GFCI should always be used
when operating the MK-170).

Cutting Tile

CaUTiON
(A)
Position the Adjustable Cutting
Guide to desired cut length as
measured from the Blade
and phase meet the requirements of the table below.
Voltage - 120V
to the requirements listed in table on page 8. An extension cord that is
too small in wire gauge (diameter), or too long in length, will cause the motor
to overheat and could cause premature failure.
Plug the GFCI into the Power
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate
for which it was.
Place the tile against the ad-
justable Cutting Guide
Cycle - 60 Hz
(B)
source.
(B)
20
OPeRaTiON
Phase - 1 Phase
(C)
Place the ON/OFF Switch in
the ON position