MK Diamond Products MK-170 Owner's Manual page 7

MK-170 Tile Saw
ON
CHeCK FOR DaMaGeD PaRTS
Before using a power tool, check for damaged parts. A guard or any other part that is
damaged should be carefully checked to determine if it would operate properly and
perform its intended function. Always check moving parts for proper alignment or binding.
Check for broken parts and mountings and all other conditions that may affect the
ON
operation of the power tool. A guard, or any damaged part, should be properly repaired or
replaced. Always check the machine for loose bolts before starting.
DiReCTiON OF ROTaTiON
A blade or cutter should always be installed so that rotation is in the direction of the
arrow imprinted on the side of the blade or cutter. It should correspond with the rotational
ON
direction of the motor. Always feed work into a blade against the direction of rotation.
NeVeR leaVe a TOOl UNaTTeNDeD
TURN POweR OFF - Do not leave a tool until it comes to a complete stop. alwaYS
ON
turn a power tool OFF when leaving the work area, or, when a cut is finished.
NeVeR disconnect any "emergency or safety devices". These devices are intended for
operator safety. Disconnection of these devices can cause severe injury, bodily harm, or
even death! Disconnection of any of these devices will void all warranties. Unauthorized
equipment modifications will void all warranties. Manufacturer does not assume
ON
responsibility for any accident due to equipment modifications.
ON
NeVeR use this machine with any cutter designed for woodworking.
ON
NeVeR operate this equipment when not feeling well due to fatigue, illness or taking medicine.
ON
NeVeR operate this equipment under the influence of drugs or alcohol.
On belt driven equipment, overtensioning of belts will result in premature crank and/or bearing
failure.
ON
Whenever necessary, replace nameplate, operation and safety decals when they become
difficult to read.
ON
alwaYS store equipment properly when it is not being used. Equipment should be stored in
ON
a clean, dry location out of the reach of children
DO NOT lend or rent this equipment without including the Owner's Manual and the Engine/
ON
Motor Manufacturer's Manual.
Check the chemical properties of the material to be cut/grinded and follow all EPA/OSHA
Regulations.
7
SaFeTY