1 BEFORE USING EQUIPMENT
Turning power off (Shutdown)
When turning OFF the power of the equipment, be sure to shut it down following the procedure
below. Check the following three points before shutdown.
No jobs should be left in the print job list. (
None of the PRINT DATA, MEMORY RX and FAX communication lamps should be blinking.
(If the equipment is shut down while any of the above lamps is blinking, jobs in progress
such as FAX reception will be aborted.)
No PC should access the equipment via the network.
Do not press the power switch to turn the power OFF, otherwise the stored data may be lost
or the hard disk may be damaged.
When the equipment is shut down, the job in progress is cleared.
1
Press the [ENERGY SAVER/
SHUTDOWN] button on the
control panel.
2
Press the [SHUTDOWN] button on the touch panel.
To cancel the shutdown operation, press the [CANCEL] button.
48
Preparation 1- Turning Power On/Off
P.272 "Job Status")