Advertisement
Transmitter Button Controls & Operation
BUTTON / CONNECTION
ON / OFF CHANNEL
Focus Nerve
Zoom Nerve
(2 Channel)
Iris Nerve
(3 Channel)
Nerve
Set Manual
A-B Stop
Record Last
Manual Setting
3D Mode
FUNCTION
ON/OFF
CHANGE CHANNEL
Automatic
Scan
Change
Motor
Direction
Set
Cancel
Restart Remote control, then apply one short press of Nerve Button.
To set 3D Mode, Press Nerve Button ten times.
Hold the On/Off button for two seconds, until display powers up.
Select a channel on both receiver and transmitter, and observe
the signal strength. When signal strength reaches 100% you may
begin automatic scan of lens.
You may cycle through 1–20 channels with a quick press of the
Channel Button to find the cleanest signal.
To start Automatic Scan of lens, press and hold for three seconds
until motor begins to turn, then release. The motor will travel one
direction to detect a hard stop and then change direction to find
the other end of the lens or hard stop. Once it finds the primary
lens, calibration is complete.
You may begin to mark your disk with desired lens information.
Note: The Control wheel has a range of digital positions (approx
-0.5 to 500) that correspond to the motor. They are displayed in
the fourth line of the transmitter's display and may be used as an
additional reference for mapping and re-mapping the lens. This is
helpful when changing lenses. You may use this reference number
for quick stops or to match a previously marked disk/lens.
Quick-press the Nerve button five times to change direction of
motor to match the side of camera from which you choose to
operate, or to change motor rotation if using Nikon or Leica lens
(where rotation is reversed).
After Automatic Scan is completed, you may wish to use a
specific range on the lens for more specific zoom or focus moves.
You can map the whole control surface of the wheel from points
A to B. Setting your A-B Stop is a combination of a button press
and rotation of the controller wheel.
To begin, set the lens in between the two positions you are
choosing. While turning the wheel toward your first stop, press
Nerve once and release. Then simultaneously press and hold
Nerve again while continuing to your first position. Change
directions and move to your second position; release the Nerve
button when you have reached your other stop. The motor will
reset in the middle of the range you have just mapped. Your A-B
stops will be mapped to the whole range of the focus wheel.
Brief Tutorial: http://vimeo.com/97558755
To cancel your A-B stop and return to Primary Lens Calibration,
double-press the Nerve button. The motor will return to the
middle of the lens position.
INSTRUCTIONS
Advertisement
