Command Line Interface - Lucent Technologies Cajun Switch P220 Release Note

If a port is inadvertently configured to use 3Com tagging, use the following procedure:
1. Reconfigure the port to use either Clear or IEEE 802.1Q tagging.
2. Copy (Save) the Running-Config to the Startup-Config.
3. Reboot the switch.
NOTES:
• 3Com VLT Tagging is not supported but can be enabled on the Cajun P550 48-port
Media Module's (M5548E-100TC) internal switch ports by using the Web or CLI
management interface.
• The Cajun P550 48-port Media Module (M5548E-100TC) has been optimized for
desktop connections. Spanning Tree topology change convergence time can be
lengthy. This could lead to loss of connectivity and/or wrongful flow of data.

Command Line Interface

The command
"set vlan <vlan-id> <port>"
trunking is enabled on that port. To set the port default VLAN for a port, use
{<mod-num>|<mod-port-range>}[...[,]{<mod-num>|<mod-port-range>}] <vlan-id>"
Cajun DocServer
NOTE: Release notes for the Cajun DocServer incorrectly excludes mention of the P550
platform. Both the Cajun P550 and P220 platforms are supported.
DVRMP
NOTE: The Cajun P550R Switch may lose a small number of DVMRP neighbor-to-
neighbor probe messages which may cause multicast routing instability under heavy
loads.
Cajun P220, P550, P550R Switch Release Notes, Release 4.0.1
is used to bind additional ports to a VLAN if
"set port vlan
.
13