Chapter 1 Read Me First - Lucent Technologies Cajun Switch P220 Release Note

Chapter 1 Read Me First

This section of the Release Notes Supporting the Cajun P220 and Cajun P550 family of switches
contains information that is crucial to know before proceeding to install or use the Cajun switch.
Please review the following release notes before continuing to the Overview section.
CAUTION: Release 4.0.1 embedded software requires a MINIMUM of 16 MB DRAM
(Dynamic Random Access Memory) to run on a Cajun P550 Layer 2
supervisor module. BEFORE upgrading, ensure that the switch meets this
16 MB DRAM requirement. A memory upgrade is not required for a Cajun
P550 Layer 3 supervisor module, or the Cajun P220.
CAUTION: Release 4.0.1 introduces a new ASCII configuration file format that replaces
the traditional binary (*.cfg) files used to store and restore saved
configurations. You must save your binary configuration before upgrading the
switch to Release 4.0.1 or rebooting the switch for the first time using Release
4.0.1. For information about saving your binary configuration, refer to the
"Installation" section of these release notes.
CAUTION: When making configuration changes to the switch, explicitly save changes by
copying the running configuration to the startup configuration to ensure that
the changes persist after the switch is restarted.
Cajun P220, P550, P550R Switch Release Notes, Release 4.0.1 3