Cybernet CyberMed H22 User Manual page 37

SDV0 LVDS:VBIOS enables LVDS driver by SDV0.
USB Configuration
Legacy USB Support
Allows USB devices to be used in MS-DOS.
EHCI Hand-off
This is a workaround for 0Ses without EHCI hand-off support.
The EHCI ownership change should be claimed by EHCI
driver.
USB transfer time-out
The time-out value for Control, Bulk, and Interrupt transfers.
Device reset time-out
USB mass storage device Start Unit command time-out.
Device power-up delay
Maximum time the device will take before it properly reports
itself to the HOST Controller.
'Auto' uses default value: for a Root port it is 100 ms, for a
Hub port the delay is taken from Hub descriptor.
F71869 Super IO Configuration
Serial Port 0 Configuration
Set Parameters of Serial Port 0 (COM A).
Serial Port 1 Configuration
Set Parameters of Serial Port 1 (COM B).
F71869 H/W Monitor
Monitor hardware status
Second Super IO Configuration
Serial Port 1 Configuration
Set Parameters of Serial Port 1 (COM C).
Serial Port 2 Configuration
Set Parameters of Serial Port 2 (COM D).
Serial Port 3 Configuration
Set Parameters of Serial Port 3 (COM E).
Serial Port 4 Configuration
Set Parameters of Serial Port 4 (COM F).
Serial Port Console Redirection
Serial Port Console Redirection.
CyberMed H22/N22 User's manual
23