Installation And Wire Connection Manual - Clarion CMS1 Owner's Manual & Installation Manual

• Contents
1. BEFORE STARTING 12
2. PACKAGE CONTENTS 12
3. INSTALLATION CAUTIONS 12
4. MAIN UNIT INSTALLATION 13
5. TUNER MODULE INSTALLATION 14
6. WIRE CONNECTION 15
1. BEFORE STARTING
1. This set is exclusively for use in vessels with a
negative ground 12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery" - " terminal
before starting. This is to prevent short circuits
during installation. (Figure 1)
Battery
Figure 1
2. PACKAGE CONTENTS
1. Main Unit 1
2. Tuner Module 1
3. Owner' manual & Installation Manual .. 1
4. 12-Pin Molex fm connector 1
5. 8-Pin DIN 10' Extension Cable 1
6. Tapping Screw M4 8
7. Machine Screw M4 2
8. Rubber Stopper 4
9. Mounting Bracket.. 1
3. INSTALLATION CAUTIONS
1. In order to avoid any interference, do not install the tuner module or control unit in the proximity of
the engine compartment.
2. The use of unauthorized parts can cause permanent damage to the unit.
3. Always check your wire connections to ensure proper installation before turning on the unit.
4. Consult with your nearest dealer for proper installation or if common parts need to be used.
Seek assistance if modifications or drilling holes to your vessel is needed.
5. Do not install the unit where it will be subjected to excessive moisture, dust, dirt, foreign particles
or vibration. Areas of high temperature from the engine, direct sunlight, heater or hot air should
also be avoided.
6. Do
not install the unit in a location where it will interfere with the vessel operation, or it will injure the
passengers if there is a sudden or emergency stop.
12
CMS1