Installation And Wire Connection - Clarion CMS2 Owner's Manual & Installation Manual

Marine digital media black box with watertight controller
Hide thumbs Also See for CMS2:
Table of Contents

Advertisement

INSTALLATION AND
CONNECTION
1. BEFORE STARTING
1. This set is exclusively for use in vessels with
a negative ground 12 V power supply.
2.
Read these instructions carefully.
3. Be sure to disconnect the battery "
before starting. This is to prevent short circuits
during installation. (Figure 1)
2. INSTALLATION CAUTIONS
1. In order to avoid any interference, do not install the tuner module or control unit in the proximity of
the engine compartment.
2. The use of unauthorized parts can cause permanent damage to the unit.
3. Always check your wire connections to ensure proper installation before turning on the unit.
4. Consult with your nearest dealer for proper installation or if common parts need to be used.
Seek assistance if modifications or drilling holes to your vessel is needed.
5. Do not install the unit where it will be subjected to excessive moisture, dust, dirt, foreign particles
or vibration. Areas of high temperature from the engine, direct sunlight, heater or hot air should
also be avoided.
6. Do not install the unit in a location where it will interfere with the vessel operation, or it will injure the
passengers if there is a sudden or emergency stop.
3.
DISPLAY CONTROLLER
1. The control unit should be mounted to a dry, clean and flat surface. Ensure the rear gasket is fully
sealed to the mounting surface without distorting the unit.
2. Select one of the three recommended methods that best fit your vessel.
M4 Tapping
Screw
4 Pcs
Flush Mount
Screw Hole
Method 1
18
CMS2
" terminal
8-Pin DIN Cable
WIRE
INSTALLATION
8-Pin DIN Cable
Flush Mount
Screw Hole
Method 2
Battery
Figure 1
8-Pin DIN
Cable
M4 Machine
Mounting
Screw
Bracket
2 Pcs
Method 3
This method requires the
purchase of the optional
BKU001 Gimbal mount
accessory

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents