PRELIMINARY – For Toro Distributor and Toro Company use only.
Cutting Deck Motor Service
14
16
7
6
5
1. Rear cover
2. Drive gear
3. Seal
4. Woodruff key
5. Nut
6. Tab washer
Disassembly (Fig. 64)
1. Plug motor ports and clean the outside of the motor
thoroughly. After cleaning, remove plugs and drain any
oil out of the motor.
2. Use a marker or scribe to make a diagonal mark
across the front flange, body and rear cover for reas-
sembly purposes (Fig. 65).
IMPORTANT: Avoid using excessive clamping
pressure on the motor flange to prevent distorting
the casting.
3. Clamp mounting flange of motor in a vise with the
shaft end down.
4. Loosen cap screws on the rear cover.
5. Take motor from the vise and remove cap screws.
6. Remove front flange from the body, then remove rear
cover. Locate and remove dowel pins from body.
Hydraulic System
10
15
9
8
3
4
7. Spider hub
8. Pressure seal
9. Back−up ring
10. O−ring
11. Body
9
15
10
12
15
11
Figure 64
DIAGONAL MARK
Page 4 − 86
1
8
33 to 40 ft−lb
2
(45 to 55 N−m)
12. Idler gear
13. Cap screw
14. Front flange
15. Dowel pin
16. Snap ring
Figure 65
Groundsmaster 4000−D
13