Hydraulic Reservoir - Toro Groundsmaster
4000?D Service Manual

PRELIMINARY – For Toro Distributor and Toro Company use only.

Hydraulic Reservoir

RIGHT
FRONT
1. Hydraulic reservoir
2. Petcock
3. O−ring
4. Strap
5. Felt strap
6. Bushing
7. Bushing
8. Hydraulic fitting
Removal
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
3. Drain reservoir into a suitable container.
4. Disconnect hydraulic hoses from reservoir.
5. Remove hydraulic reservoir using Figure 84 as a
guide.
Hydraulic System
23
19
8
7
6
1
3
2
4
21
9. Stand pipe
10. Hose clamp
11. Screen filter
12. Dipstick
13. O−ring
14. Reservoir cap
15. Suction hose
16. Tank strainer w/O−ring
Page 4 − 112
14
18
10
13
9
12
11
24
4
16
5
20
4
22
22
Figure 84
Inspection
1. Clean hydraulic reservoir and suction strainer with
solvent.
2. Inspect for leaks, cracks or other damage.
Installation
1. Install reservoir using Figure 84 as a guide.
2. Using a wrench, turn strainer into port at least 1−1/2
to 2 full turns beyond finger tight.
3. Reconnect hydraulic hoses.
4. Fill reservoir with hydraulic fluid as required.
15
17
30 to 40 in−lb
(minimum)
(3.4 to 4.5 N−m)
17. Hose clamp
18. Hose
19. Hose clamp
20. Cap screw
21. Cap screw
22. Lock nut
23. Hose
24. Hose
Groundsmaster 4000−D