Default Settings - Buffalo TeraStation 1000 User Manual

Information Code
I33
I37
I38
I41
I42
I45
I46
I47
I52
I54
I55
Amber (Not Blinking)
When the power LED glows a steady amber, a new firmware version is available. Update the firmware to the newest
version.

Default Settings

Administrator's Name
Password
Shared Folders
DHCP Client
Registered Groups
Description
An error occurred in replication,
or synchronization between the
main TeraStation and the backup
TeraStation failed during the replication
configuration.
System recovery in progress.
System recovery is complete.
Press the function button on the front to
start the recovery process.
Preparing to start the recovery process.
Recovery failed.
Data migration or conversion (RAID
migration) is in progress.
Data migration or conversion (RAID
migration) is in progress.
A new firmware version has been
released.
A backup job has failed.
Authentication during recovery of
settings failed.
admin
password
"share" (for both Windows and Mac computers). The recycle bin is enabled
on "share" by default.
Normally, the TeraStation will get its IP address automatically from a DHCP
server on the network. If no DHCP server is available, then an IP address
will be assigned as follows:
IP address: 169.254.xxx.xxx (xxx is assigned randomly when booting the
TeraStation.)
Subnet mask: 255.255.0.0
"hdusers", "admin", and "guest" are default groups and cannot be edited or
deleted.
Corrective Action
In Settings, navigate to Backup -
Replication and click Resync to execute
resynchronization. If the error is
displayed again, contact Buffalo
technical support for assistance.
-
-
-
-
-
Don't turn off the TeraStation.
Don't turn off the TeraStation.
Update the firmware.
Make sure that the backup job is
configured correctly. Make sure that the
NAS is on and not in standby mode. If
the backup job still fails to run correctly,
check the status of the NAS, network,
and backup source and destinations.
Settings can only be restored for the
TeraStation whose settings were
originally saved. To restore settings,
insert the USB memory device, turn
on the TeraStation while holding
down the init button on the rear of the
TeraStation, and restart the TeraStation.
Or, settings can be restored in Settings
with the TeraStation powered on.
93