Buffalo TeraStation 1000 User Manual page 71

Note: To delete a client, check the hostname and click Delete Client.
11
Enter the IP address and hostname of the NFS client, then click OK.
12
Click Close.
13
Enter the mount command to access the shared folder from the NFS client.
The mount command depends on your operating system. The examples below assume that IP address of your
TeraStation is 192.168.11.10, "/mnt/array1/share" is the desired NFS path, and "/mnt/nas" or drive letter "z" is
the mount point.
For Linux:
mount -t nfs 192.168.11.10:/mnt/array1/share /mnt/nas
For Windows Service for Unix 3.5:
mount 192.168.11.10:/mnt/array1/share z:
For Solaris 10:
mount -F nfs 192.168.11.10:/mnt/array1/share /mnt/nas
Notes:
• To restrict NFS access to a specific network or client, navigate to File Sharing - NFS - Services and click Edit.
Enter the address of the network. For example, if your local network subnet has a router at 192.168.1.1 and
clients with IP addresses in the range from 192.168.1.2 through 192.168.1.48 with subnet mask 255.255.255.0,
then the "Public Network Address" would be 192.168.1.0 and the "Public Subnet Mask" would be
255.255.255.0. This would mean that only clients on this local network would be able to access the NFS share.
If the default settings are used (0.0.0.0 for both the public network address and the public subnet mask), then
access to the NFS share will not be restricted.
• To use NFS folders with VMware ESX/ESXi or Citrix, navigate to Services - Edit and change the operation mode
from "User Mode" to "Kernel Mode".
• Async is the default for NFS rules. Sync is available only when the device is in kernel mode.
70