Applying Settings - Buffalo TeraStation 1000 User Manual

Notes:
• The USB memory device should have a capacity of at least 1 GB.
• Any data stored on the USB memory device will be deleted.
2
In Settings, click Management
3
Click to the right of "Restore/Erase".
4
From "Target USB drive", select the USB memory device that is connected to the USB 2.0 port of the
TeraStation.
5
Select "Save current configuration to a USB drive". Click Execute.
6
The "Confirm Operation" screen will open. Enter the confirmation number, then click OK.
7
When the following message is displayed, saving settings is finished. Click OK.
Troubleshooting:
If the settings are not saved to the USB memory device successfully, you may receive the error message "The
specified operation cannot be executed". Verify:
• The device has a capacity of 1 GB or larger.
• The device is not write-protected.
Note: If you changed any hostname or network settings since your last backup, save your settings again to the
USB memory device again.

Applying Settings

The saved settings can be applied to a different TeraStation (of the same series). There are two ways to apply settings
from the USB memory device.
Applying from Settings
1
Connect the USB memory device with the saved settings to a USB 2.0 port (not a USB 3.0 port) of the
TeraStation.
2
In Settings, click Management.
75