LSI LSI20860 User Manual page 14

1-6
Note: Notice that the components on a PCI host adapter face the
opposite way from non-PCI adapter boards you have in
your system. This is correct, and the board is keyed to go
in only one way.
Step 7. The bracket around the external connector J3 should fit where
the blank panel was removed. Secure it with the bracket screw
before making the internal and external SCSI bus connections.
See Figure
Step 8. To connect any internal SCSI device, plug a 50-pin connector
on the end of the internal SCSI ribbon cable into the J2
connector.
Step 9. Make sure the connection to the opposite end of the ribbon
cable has been made to a SCSI device. See
Step 10. Replace the cabinet cover as described in the user's manual for
your computer.
Step 11. Make all external SCSI bus connections. Finally, refer to the
PCI Storage Device Management System SDMS 4.0 User's
Guide (or the guide for the software that you will use) to load
the driver software for your particular operating system.
Using the LSI20860
1.2.
Figure 1.3.