Table of Contents
Advertisement
Configuration
(Standalone)
Automatic
Programs
Sound-Active
Mode
Custom Mode
Auto-Program
Speed
Sound Sensitivity
Temperature
Shocker™ Panel 180 USB User Manual Rev. 1
Set the product in one of the standalone modes to control without a DMX controller.
Connect the product to a suitable power outlet.
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX
signals that could interfere with the DMX signals from the controller.
To run the Shocker™ Panel 180 USB in automatic mode, follow the instructions below:
1.
Press <MENU> repeatedly until P-- shows on the display.
2.
Press <ENTER>.
3.
Use <UP> and <DOWN> to select an auto program P 1–P 8.
4.
Press <ENTER>.
To run the Shocker™ Panel 180 USB in sound-active mode, do the following:
1.
Press <MENU> repeatedly until SNd shows on the display.
2.
Press <ENTER>.
3.
Use <UP> and <DOWN> to select a sound-active program Snd1 or Snd2.
4.
Press <ENTER>.
The product will only respond to low frequencies of music (bass and drums).
To custom mix a static color, follow the instructions below:
1.
Press <MENU> repeatedly until U-- shows on the display.
2.
Press <ENTER> and dxxx will show on the display:
3.
Use <UP> and <DOWN> to increase or decrease the dimmer value.
4.
Press <ENTER> and Sxxx will show on the display.
5.
Use <UP> and <DOWN> to increase or decrease the strobe speed.
To change the auto-program speed on the Shocker™ Panel 180 USB, do the following:
1.
Press <MENU> repeatedly until S-- shows on the display.
2.
Use <UP> and <DOWN> to increase or decrease the program speed (S 1–S100).
3.
Press <ENTER>. The product will return to the last selected mode.
To change the sound sensitivity on the Shocker™ Panel 180 USB, follow the instructions
below:
1.
Press <MENU> repeatedly until SenS shows on the display.
2.
Use <UP> and <DOWN> to increase or decrease the sound sensitivity (u 0–u100).
3.
Press <ENTER>. The product will return to the last selected mode.
To view the current temperature of the Shocker™ Panel 180, follow the instructions below:
1.
Press <MENU> repeatedly until teMP shows on the display.
2.
Press <ENTER>.
Page 13 of 19
Advertisement
Table of Contents
