Advertisement
Advertisement
Table of Contents
Related Manuals for STIEBEL ELTRON DHC 6 EL
Summary of Contents for STIEBEL ELTRON DHC 6 EL
- Page 2 - Children should be supervised to ensure that they do not play with the appliance. STIEBEL ELTRON...
-
Page 3: Operation Instruction
Level heats the water to a Description of the unit (External) Fig 1 1.3 Description of the unit (External) b. Temperature Control knob e. Cold Water Inlet Pipe STIEBEL ELTRON... - Page 4 For electrical heating appliances refrain from taking any action. Please contact does not reset automatically, if you would the Stiebel Eltron Service Center for further like to reset the unit, the mains power inspections and repairs to be made. 1.4 This model features an Earth Leakage Circuit Breaker (ELCB) (Type EC only), which should be test a monthly.
- Page 5 WARNING: When selecting an appropriate water temperature, the temperature may be dangerously high, especially for children. Keep away from the hot water outlet, as it may cause a potential scalding hazard. STIEBEL ELTRON...
-
Page 6: Important Notes
The device must be capable of being isolated from the mains, The unit must be connected to for example by fuses, with an isolating the protective earth conductor (see electric circuit diagram). distance of at least 3.5 mm. in all poles. STIEBEL ELTRON... -
Page 7: Installation Location
For guarantees please refer to the respec- liability for any failure caused tive terms and conditions of supply for by inproper installation and / or your country. unauthorized installers. The installation, electrical of this appliance should be carried STIEBEL ELTRON... - Page 8 9. Fault elimination for the user through the unit. required for the unit to turn it on has not been reached. - Heating setting too low - Turn knob to the right (max. position) - ELCB activated. - Turn ELCB Reset button. STIEBEL ELTRON...
-
Page 9: Installation Instruction
16. Circuit board cover (Fig 7#3) 10. Reed switch 17. Cover 4. Distance of the connection 11. ELCB Test (option) cable (Fig 6#4) 12. ELCB Reset (option) 5. Thermostat 6. Cable entry with seal Description of the unit (Internal) Fig 3 STIEBEL ELTRON... - Page 10 Installation Instruction Installation to a bath / sink. Fig 4 65 mm G1/2 100 mm 35 mm 110 mm. 200 mm Fig 5 Fig 6 STIEBEL ELTRON...
- Page 11 D - Thermal cut-out 4 x 35 mm E - Temperature Sensor (Inlet) 6 mm F - Temperature Sensor (Outlet) Fig 7 Fig 8 G - ELCB (option) Wall Mounting 4 x 35 mm 4,3 mm Fig 9 STIEBEL ELTRON...
- Page 12 - Create an opening for the water - Remove the screw from underneath inlet in the case of wall-embeded and the water heater to open the cover of the wall-mounted pipes. unit. (concealed connection) Fig 11 Fig 13 STIEBEL ELTRON...
- Page 13 - Insert the wires into the respective openings according to the diagram, and fasten the screws to secure the wires tightly. Please en- sure that the correct size of wire is used. STIEBEL ELTRON...
- Page 14 The cold water pipe must be turned to the joints (both hot and cold water), using a on in order to rinse it before rubber leakage gasket (Fig 18/C) between installation. Pressure-resistant equipment the joints. must be used in compliance with accepted standards. STIEBEL ELTRON...
- Page 15 Installation Instruction - Install the cover. Connect the power - After installation is complete, close cord between the circuit board and the cover. the casing and screw in tightly. Fig 22 Fig 20 Fig 21 STIEBEL ELTRON...
Need help?
Do you have a question about the DHC 6 EL and is the answer not in the manual?
Questions and answers