Page 1
DHC 8 EL English Instantaneous water heater - Operation and installation instructions This water heater must be installed (water and electrical installation), commissioned and serviced by approved service technicians in accordance with these instructions.
Page 3
- Children should be supervised to ensure that they do not play with the appliance. STIEBEL ELTRON...
Page 4
1.1 Description of the unit. of ~ 50 C The DHC 8 EL fully electronic instanta - Level heats the water to a neous water heater heat the water while it maximum temperature is owing through the unit.
Operation Instruction for the user and the quali ed installer The DHC 8 EL water heater unit is 1.4 This model features an automatic to be installed in a closed, frost-free cuto device that functions when the room (disconnected units are to be stored in water temperature is unusally high.
Page 6
2. First Operation - The indicator light will show. - The DHC 8 EL Water Heater features The water heater should rst be operated a temperature control knob at the front by an expert technician only.
Operation Instruction for the user and the quali ed installer 3. Technical Data Type DHC 8 EL Norminal capacity 0.45 Design Close outlet Max. water pressure 1000 kPa Min. water pressure to activate unit 200 kPa Water connection G ½“ (External Thread) (15mm)
/ or your country. unauthorized installers. The installation, electrical connection and rst operation of this appliance should be carried out by a quali ed installer. STIEBEL ELTRON...
Page 9
- Increase ow volume through the unit. required for the unit to turn it on has not been reached. - Water ow too high - Reduce water ow - Heating setting too low - Turn knob to the right (max. position) STIEBEL ELTRON...
9. Reed switch (Fig 7#3) 10. Cold water connection 4. Distance of the connection 11. Hot water connection cable (Fig 6#4) 12. Flow limiter 5. Thermostat 6. Cable entry with seal Description of the unit (Internal) Fig 3 STIEBEL ELTRON...
Page 11
Installation Instruction for the quali ed installer Installation to a shower / sink. Fig 4 Dimension Cable 65 mm G1/2 100 mm 35 mm 110 mm. 200 mm Fig 5 Fig 6 STIEBEL ELTRON...
Page 12
D - Thermal cut-out 4 x 35 mm E - Temperature Sensor (Inlet) 6 mm F - Temperature Sensor (Outlet) Fig 7 Fig 8 G - ELCB (option) Wall Mounting 4 x 35 mm 4,3 mm Fig 9 STIEBEL ELTRON...
Page 13
- Create an opening for the water - Remove the screw from underneath inlet in the case of wall-embeded and the water heater to open the cover of the wall-mounted pipes. unit. (concealed connection) Fig 11 Fig 13 STIEBEL ELTRON...
Page 14
- Insert the wires into the respective openings according to the diagram, and fasten the screws to secure the wires tightly. Please en- sure that the correct size of wire is used. STIEBEL ELTRON...
Page 15
The cold water pipe must be turned to the joints (both hot and cold water), using a on in order to rinse it before rubber leakage gasket (Fig 18/C) between installation. Pressure-resistant equipment the joints. must be used in compliance with accepted standards. STIEBEL ELTRON...
Page 16
- Install the cover. Connect the power - After installation is complete, close cord between the circuit board and the cover. the casing and screw in tightly. Fig 22 Fig 20 Fig 21 ig 21 STIEBEL ELTRON...
Need help?
Do you have a question about the DHC 8 EL and is the answer not in the manual?
Questions and answers