Xerox DocuColor 2045 System Administration Manual page 42

T M
O O L S O D E
1– 2 0
2
Follow the directions on the screen and touch the button for the value you wish
to adjust.
3
Touch the up or down arrow buttons until the value you want is displayed in the
field above the arrow buttons.
KEY POINT: You should not adjust the value more than 5 counts at a time.
4
Touch the Enter button on the screen.
5
Repeat steps 2, 3, and 4 to enter other new values.
6
Press the Start button on the Control Panel to enter the new values into the
system.
KEY POINT: It is recommended that you run the Check Gradation procedure
for the screening type that you are adjusting. Do a before and after comparison
to verify your changes.
D C
O C U O L O R
20 6 0/ 20 4 5 S A
Y S T E M
G
D M I N I S T R A T I O N U I D E