Daily Use; Helpful Hints And Tips - Zanussi ZGL640TW User Manual

Daily use

Warning! Refer to "Safety information"
chapter.
Ignition of the burner
Warning! Be very careful when you use
open fire in kitchen environment.
Manufacturer decline any responsibility in case
misuse of the flame
Always light the burner before you put
cookware.
To light the burner:
1. Push and hold the spark generator button
.
2. At the same time turn the control knob
counterclockwise to the maximum position
and push it down to light the burner.
3. Release the spark generator button when
burner lights but keep the control knob on
this position for approximately 5 seconds;
this will let thermocouple to warm up. If
not, the gas supply will be interrupted.
4. Adjust the flame after it is regular.
If after some tries the burner does not
light, check if the crown and its cap are in
correct positions.

Helpful hints and tips

Warning! Refer to "Safety information"
chapter.
www.zanussi.com
A) Burner cap
B) Burner crown
C) Ignition candle
D) Thermocouple
If the burner does not light after 15 seconds,
release the control knob, turn it into off position
and try to light the burner again after minimum
1 minute.
Important! In the absence of electricity you
can ignite the burner without electrical device;
in this case approach the burner with a flame,
push the relevant knob down and turn it
counter-clockwise to maximum gas release
position.
light the burner again after minimum 1 minute.
stallation or a power cut. It is normal.
Turning the burner off
To put the flame out, turn the knob to the sym-
bol
A
from the burner.
B
C
D
Energy savings
• If possible, always put the lids on the pans.
Warning! Do not keep the control knob
pushed for more than 15 seconds.
If the burner accidentally goes out, turn the
control knob to the off position and try to
The spark generator can start automatical-
ly when you switch on the mains, after in-
.
Warning! Always turn the flame down or
switch it off before you remove the pans
5