Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi ZGL62I
Summary of Contents for Zanussi ZGL62I
- Page 1 User manual Gas hob ZGL62I...
-
Page 2: Table Of Contents
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 What to do if…... - Page 3 damage to property caused by failure to obey these re- tions. Particular attention must be given to the relevant quirements. requirements regarding ventilation. • To prevent the risks of structural damage or physical • The use of a gas cooking appliance cause heat and injury, installation, connection of the appliance to the moisture in the room in which it is installed.
-
Page 4: Installation
Installation Gas Connection Warning! The following instructions about installation, connection and maintenance must be Warning! Any gas installation must be carried out carried out by qualified personnel in compliance with by a GAS SAFE REGISTER installer. standards and local regulations in force. Make sure that, once the hob is installed, it is easily ac- Important safety requirements cessible for the engineer in the event of a breakdown. - Page 5 Important! Failure to ensure the correct assembly will Minimum adjustment screw cause leakage of gas. 5. Make sure the flame does not go out when you quick- Important! Make sure that the gas supply pressure of the ly turn the knob from the maximum position to the minimum position.
- Page 6 Brown - Live 1. Connect the green and yellow (earth) wire to the ter- minal in the plug which is marked with the letter 'E' or the earth symbol or coloured green and yellow. 2. Connect the blue (neutral) wire to the terminal in the plug which is marked with the letter 'N' or coloured black.
-
Page 7: Product Description
120 cm min 20 mm (max 150 mm) 60 mm 180 cm 2 360 cm MANUFACTURER: ELECTROLUX ITALIA S.p.A. C.so Lino Zanussi, 30 33080 PORCIA (PN) - ITALIA Product description Cooking surface layout Semi-rapid burner Semi-rapid burner Control knobs Auxiliary burner... -
Page 8: Operation
Operation Ignition of the burner Warning! If the burner does not light after 15 seconds, release the control knob, turn it into off Warning! Be very careful when you use open fire in position and try to light the burner again after minimum 1 kitchen environment. -
Page 9: Care And Cleaning
Care and cleaning • Make sure you position the pan supports correctly after Warning! Switch the appliance off and let it cool cleaning. down before you clean it. Disconnect the appliance from the electrical supply, before carrying out any • To make burners work correctly, make sure that the cleaning or maintenance work. -
Page 10: Technical Data
Labels supplied with the accessories bag dealer may not take place free of charge, even during the warranty period. Stick the adhesive labels as indicated below: MOD. MOD. MOD. TYPE PROD.NO. 230V-50Hz PROD.NO. PROD.NO. 0049 SER.NO. IP20 SER.NO SER.NO 03 IT DATA DATA MADE IN ITALY... -
Page 11: Environment Concerns
By-pass diameters Burner Ø By-pass in 1/100 mm. Semi-rapid Burner Ø By-pass in 1/100 mm. Rapid Auxiliary Gas burners BURNER NORMAL REDUCED NORMAL POWER POWER POWER NATURAL GAS G20 (2H) 20 mbar (Butane/Propane) G30/G31 (3+) 28-30/37 mbar inj. 1/100 m³/h inj. - Page 12 www.zanussi.com/shop...