Shock Absorber Adjusters - Ducati 999 Owner's Manual

Shock absorber adjusters

The rear shock absorber has outer adjusters that enable
you to adjust your motorcycle to the load.
The adjuster (1) located on the left side, on the
connection holding the shock absorber to the swingarm,
controls rebound damping.
The adjuster (2) on the shock absorber expansion
reservoir controls compression damping.
Turn the adjusters (1 and 2) clockwise to increase
damping, anticlockwise to reduce it.
(999)
Rebound adjuster (1) STANDARD setting:
turn the adjuster all the way in (clockwise) then slacken it
1 turn and a half.
Compression adjuster (2) STANDARD setting:
turn the adjuster all the way in (clockwise) then slacken it
1 turn.
(999S)
STANDARD setting:
turn the adjusters (1 and 2) all the way in (clockwise) then
slacken them 14 clicks.
Two ring nuts (3), located on the top section of the shock
absorber are used to adjust the outer spring preload.
To change spring preload, slacken the upper ring nut.
Then tighten or slacken the lower ring nut to increase
or decrease spring preload as required. Once spring
preload has been set, tighten upper ring nut.
(fig. 37.1 - 37.2)
2
1
999
2
999S
3
E
fig. 37.1
3
1
fig. 37.2
43