Table of Contents
Advertisement
The Yoke
Adjusting Yoke Position
The Neeva provide for two yoke configurations; the standard use position and a low clearance
position. To change the fixture from its standard position, remove the yoke locking knobs,
screws, washers, and hex bolts from either side of the fixture. Move the yoke to the alternate
position and reinstall the hardware.
Add figure 3 here showing yoke configurations
Note: In neither position will the Neeva be able to be turned through the yoke with DMX
cables attached. To rotate yoke past the rear panel it is necessary to remove the DMX
cables.
Adjusting fixture angle
Loosen the yoke locking knobs but do not remove them. Tilt the fixture to the desired angle and
then tighten the yoke locking knobs to set in that position.
Cleaning Lenses
Keeping the Neeva optical system clean will greatly enhance it performance. Please follow
these easy instructions to get the best results.
Do not use commercial glass cleaners these contain harsh chemicals that may damage your
optics. The most perfered choice is Isopropyl alcohol. Optionally you can use distilled water or a
50/50 mixture of Isopropyl alcohol and distilled water. Always use a clean, lint-free cloth, ideally
one designed for this purpose.
Advertisement
Table of Contents
