Adjustments; Focusing The Beam; Shaping The Beam - Strong Neeva User Manual

give a White output. To do this we lower the output of the brightest colors to match the output
of the lowest color. You can override this setting to meet your own operational requirements. In
the Led Cal menu.
Led Cal
Press Enter and then use the Up or Down function to move through the four color levels. The
value 255 represents full output and each of the four channels in a Neeva can be adjusted.
Once adjusted the total output of a change is proportional to the level you set in
Red Cal
XXX
In some cases you might fine that the factory balance is not to your liking or you may just want
the fixture to output the maximum level of light with no regard to the color balance. In these
cases adjust the Neeva to your desired effect.

Adjustments

Focusing the beam

To focus the beam loosen the two beam focus knobs located on the top and bottom of the lens
tube. Slide the lens tube forward or backward to achieve a sharp focus.
Note: Due to the unique nature of the Neeva LED Profile a soft focus is not desirable.
Best results are achieved by using your choice of diffusion materials when you want to
achieve a soft focus effect.
After you have the fixture in focus, tighten the beam focus knobs.

Shaping the beam

The beam can be shaped using the four built-in shutters or via the drop in pattern holder. The
pattern holder slot in just in front of the shutters. The supplied patter holder is a B-Size device
and hold 2.5" and 2.75" patterns.
Note: Because the Neeva has a 2.125 inch aperture it is recommended that the image
area of a pattern be limited to 2 inches or less for best results.
A drop-in slot is located in front of the pattern holder slot that is designed for optional iris or
pattern spinning devices. A small cover is installed to prevent light leaks when an accessory is
not installed. Loosen the two screws that hold the cover (do not remove) and slide the cover
forward so that the accessory can be installed. Fit the cover appropriately to the accessory and
tighten the screws. When installing an accessory device in this slot make sure to follow the
accessory manufactures instructions.
Led Cal
.