Overview Neeva Exploded View Drawing Neeva is a LED profile spotlight. Rather than using an incandescent lamp, a dimmer and a color filter to create lighting levels and moods Neeva is directly DMX controllable to create a wide range of lighting levels and moods.
User Interface Conventions The Neeva features a robust user interface that consists of a two line LCD display and four buttons. The left button below the display in the “Menu” function, the right button is the “Enter” function and the two buttons on the side are the “Up” and “Down” functions. For the purpose of this manual any time you see these four functions listed in bold type this refers to pressing that function button.
Up/Down arrow will return to the first line of the display allowing you to either return to the main display or use the Up and Down functions to access other fixture functions. Recording Scenes Auto menu is used to enable and record scenes for standalone operation of the Neeva. Auto...
Auto To start the menu use the Enter function from the display. Player From this screen you can use the Enter function to move the Up/Down arrow to the second Player line and then change the state of the from by using the Up or Down function.
Like all LED based lighting fixtures the Neeva mixes colors based on the propotional use of Red, Green and Blue LEDs. Neeva adds to this with an extra channel of White LEDs to expand the range of possible colors. The Neeva is set at the factory to balance the RGB mix of the LEDs to...
Led Cal Press Enter and then use the Up or Down function to move through the four color levels. The value 255 represents full output and each of the four channels in a Neeva can be adjusted. Led Cal Once adjusted the total output of a change is proportional to the level you set in...
Add figure 3 here showing yoke configurations Note: In neither position will the Neeva be able to be turned through the yoke with DMX cables attached. To rotate yoke past the rear panel it is necessary to remove the DMX cables.
Page 10
The optical system consists of three lenses. To access these it is necessary to remove the lens tube and separate the rear housing of the fixture from the lens barrel (see figure 1). Additionally you will have to open the lens tube to remove the lens from the tube for best results. To open the lens tube, remove the two screws from the bottom side of the color frame holder.