Table of Contents
Advertisement
To start the menu use the Enter function from the
Player
On
From this screen you can use the Enter function to move the Up/Down arrow to the second
line and then change the state of the
Alternatively, you can use the Up and Down functions while the Up/Down arrow is on the first
line to move to the next menu. The first of these is the
Fact
Settings
If you use the Enter function you will see the
function will reset your fixture to original Factory Settings clearing your scene memory.
Programming Steps
Player
If you are at the
Edit Steps
display.
Edit
Steps
When you use the Enter function you will see the
Edit
Step X
There are four steps available of edit. Use the Up and Down functions to move to the step you
wish to edit. Use the Enter function to drop down into a new set of menus. These are
Delay
Speed
White, Blue, Green
,
,
values for each of these step attributes. Use the Menu function to move up from each value to
be able to proceed to the next attribute.
Enable
The
screen can be set to
show.
Once you have programmed your steps and enabled them you can use the
On.
the fixture to
This will place the fixture in
Off
screen to
returns the fixture to DMX mode.
Player
from
Fact Set?
screen display show above you can use the Up function to proceed to the
Red
, and
. Use the Enter, Up and Down function buttons to set
On
Off
or
. This chooses the steps that will be part of your
Auto
display.
On
Off
to
by using the Up or Down function.
Fact Settings
screen and a second press of the Enter
Edit Step X
display.
Auto
mode and play your show. Turning the
menu.
Enable
Player
screen to set
Player
,
Advertisement
Table of Contents
