Table of Contents
Advertisement
Dmx:
The word after
from a control source or not. It the fixture is in Auto mode you will not be able to access this
screen no matter how many times you press the Menu function. You will see a display like this:
Auto:On
Step: X
Dmx
From either the
fixture functions. For detailed information on
Scenes below.
Setting DMX Address
Setting the DMX address is likely to be the most common operation accessed via the user
interface. From the home display do this press the Enter function:
DmxAdr
XXX
Use the Enter function to move the Up/Down arrow to the lower line of the display. The value
on the second line of the display will now be shown with brackets around that value. This
indicates that the Up and Down function have incremented that value and that you must use the
Enter function to save this new value. Pressing the Menu function at any point will move you up
the path you took to get to your current display and will not record a pending change in value.
DmxAdr
[XXX]
Use the Up and Down functions to increment the display to the desired address. Once that
address is displayed use the Enter function to confirm that value. Then press the Menu function
and the Up/Down arrow will return to the first line of the display allowing you to either return to
the main display or use the Up and Down functions to access other fixture functions.
Recording Scenes
Auto
The
menu is used to enable and record scenes for standalone operation of the Neeva.
Auto
On
Off
will be either
or
Auto
or
screen simply press the Enter function to access the full set of
indicating that the fixture is either receiving DMX
Auto
operation see the section on Recording
Advertisement
Table of Contents
