Care And Cleaning; Door Seal; Before Calling For Service - Sharp SJ-FR23C Operation Manual

CARE AND CLEANING

■ Caution
Unplug the refrigerator.
●
Wipe with a soft cloth dipped with warm water
●
or diluted neutral detergents
(e.g. tableware detergent).
If neutral detergents are used, please wipe with
●
water again before drying.
(Otherwise, the plastic components may be damaged.)
Appendage
Take off, wash and dry
before reinstallation.

Door Seal

Please be careful since
it gets stained easily.
The Wall Surrounding
and Adjustable Foot
（Please care and maintain
once a year.）
The color of the wall behind may
get change if it doesn't get cleaned
for a long time.
Deforsting
The refrigerator defrosts to water regularly and stores in the evaporation pan, then the water gets evaporated by the heat generated
from compressor.
The Inner Light Is Broken
Please contact the service centre authorized by SHARP to replace the Inner Light. Only qualified technician can do the replacement.
Switch Off the Refrigerator
Please switch off the refrigerator if you will be not at home for a long period, take out all the foods in the refrigerator and clean the
inside thoroughly. Please remove the plug from the socket and keep the doors of the refrigerator all open.

BEFORE CALLING FOR SERVICE

Before calling for serive,check the following points.
It is normal for the refrigerator to produce the
following sounds.
・Loud noise produced by the compressor when
operation starts --- Sound becomes quieter after
a while.
・Loud noise produced once a day by the compressor
--- Operating sound produced immediately after
automatic defrost operation.
・Sound of flowing fluid (gurgling sound,fizzing sound)
--- Sound of refrigerant flowing in pipes
(sound may become louder from time to time).
6
How to Remove and Install
Fresh Case
Draw the Fresh Case out until reaching the ledge,
lift up the inside part slightly and then take it out all.
Fresh Case Lid
Fresh Case
Put it on the ledge and push it along the rail when
installing.
Do not remove the lid.
The following substance shall never
be used, otherwise it will cause
damage to the surface, change of
shape, crack to the plastic
components.
・gasoline
・diluent
・alcohol
・abrasive powder
・washing powder
・steel wool
・nylon brush
・hot water (>60℃)
Door Pocket
Pull it out by lifting up.
Make sure the hasp
is fully locked.
Ledge
Cracking or crunching sound --- Sound produced
・
by expansion and contraction of inner walls and
internal parts during cooling.
Squeaking sound --- Sound produced by expansion
・
and contraction of internal parts.
It is normal that the outside of a cabinet may
be hot when touched.The hot pipe is in the cabinet
in order to prevent dew generation.
IF YOU STILL REQUIRE SERVICE
Refer to your nearest service agent approved by SHARP.
・alkaline and
alkalescent detergent
・substances may cause
damage to the plastic
components
Hasp