Care And Cleaning - Sharp SJ-FTS13BVS Operation Manual

Care and cleaning

Important
Follow the tips below to prevent cracks on the inner
surfaces and plastic components
• Wipe out food oil adhered to plastic parts.
• Some household chemicals may cause damage, so use
only diluted washing-up liquid (soapy water).
• If undiluted detergent is used or soapy water is not
wiped off thoroughly, it may result in cracks of plastic
parts.
Cleaning
For hygienic reasons, make sure to do following
things regularly.
Remove the accessories (e.g. shelves) from the cabinet
and the door. Wash them by warm soapy dishwashing
water. After that, rinse them in clean water and dry.
Clean the inside with a cloth soaked in warm soapy
dishwashing water. Then, use cold water to wipe off
soapy water thoroughly.
Wipe the exterior with a soft cloth each time it gets
dirty.
Clean the Magnetic door seal with a toothbrush and
warm soapy dishwashing water.
Do not put on the shelf on the protrusions.
Make sure to put the shelf on the rail.
The hooks of the shelf must be frontside and
downward.
If the shelf is not placed correctly, it may fall down.
Protrusions
Rail
Protrusions
Do not remove the air inlet of the freezer compartment.
If you remove them forcibly, it may cause deformation
of the parts.
Note
• After cleaning, make sure to put the shelves and the
cases on original position.
• Do not use heavy-duty cleansers or solvents (lacquer,
paint, polishing powder, benzine, boiled water, etc.)
which may cause damages.
• If you pull out the power plug once, wait 5 minutes at
least before connecting the power plug again.
• The glass shelves are heavy to carry. Hold them rmly
when you remove the shelves from the cabinet.
• Do not drop objects inside the refrigerator or strike the
inner wall. This may cause cracks to inner surface.
Rail
Hook
Defrosting
Defrosting is automatically operated by a unique energy
saving system.
When the compartment light is blown
Contact the service agent approved by SHARP to replace
the light. The light is not to be replaced other than by
quali ed service personnel.
Switching off your refrigerator
If the refrigerator needs to be switched off for an extended
period, the following steps should be taken to reduce the
growth of mold:
1. Remove all food.
2. Remove the power plug from the socket.
3. Clean and dry the interior thoroughly.
4. Keep all the doors open slightly for a few days to dry.
EN-9