Table of Contents
Advertisement
Connecting to a Power Source
To connect a device to a power source:
1.
Insert the power cable plug directly into the receptacle located at the back of
the device.
100-240 V
50-60 Hz 2 A
2.
Plug the other end of the cable into a grounded, 3-pin socket.
Note:
For International use, you may need to change the AC line cord. You must use
a line cord set that has been approved for the receptacle type in your country.
3.
Check the front-panel LEDs as the device is powered on to be sure the Power
LED is lit. If not, check that the power cable is correctly plugged in.
4.
If you have purchased a Redundant Power Unit, connect it to the device and to
an AC power source now, following the instructions included with the package.
Figure 3-4. Power Receptacle
Connecting to a Power Source
DC Input
V
A
3.3
30
5
6
12
0.7
3-5
Advertisement
Table of Contents
