Matrox MXO2 Installation And User Manual page 144

130
Playhead and scrubber bar
Scrubber
bar
The playhead shows the location of the currently displayed frame within your
clip. The timecode of the playhead's current position is displayed just below the
scrubber bar.
The active video portion of your clip, that is, the portion of video that will be
played back, is defined by the In and Out points and is shown in green. The
portions of video that fall outside the specified In and Out points are considered
inactive video and will not be played back by Vetura Playback. You can set/adjust
the In and Out points on the scrubber bar by dragging the left or right end of the
green (active video) portion of your clip. To adjust the In and Out points while
maintaining the active video duration, use the active video handle to drag the
entire active video segment left or right.
To navigate to a specific location within your clip using the scrubber bar, click to
the desired location in your clip, or drag the playhead to the desired location. For
more options on navigating through your clip, see
page
Chapter 11, Using Matrox Vetura Capture and Vetura Playback
Jog Control
your clip.
¦ Note You can also drag the playhead to navigate through
your clip (see
In point
Inactive video
128 and "Keyboard shortcuts"
Drag the jog control left or right to navigate within
"Playhead and scrubber bar"
Active video Playhead
handle
on page 137.
on page 130).
Out point
Inactive video
"Playback controls" on