Rorke Data Galaxy Aurora Series Configuration And System Integration Manual page 34

G A L A X Y ® A U R O U R A
A list of ports of your Infiniband card will be displayed. On the client used for
this example, a Mellanox Infinihost III LX – single port HCA, the following port
info was displayed:
srp-mthca0-1
Once you know the port id, type the following command:
ibsrpdm -c >/sys/class/infinitand_srp/{port}/add_target[enter]
Where {port} is the name of the port that the array is physically connected to.
Using the example from above:
ibsrpdm –c
1/add_target[enter]
The LUN will appear as a block device. If you type the following command:
lsscsi[enter]
You should see something like the following:
[0:0:0:0] disk
[0:0:1:0] cd/dvd PIONEER DVD-RW DVR-109 1.40 /dev/sr0
[2:0:0:0] disk
Skip to the Linux Fibre Channel and LUN formatting section for further
instructions to continue to prepare the Aurora storage for Linux clients.
33
C O N F I G U R A T I O N A N D
>/sys/class/infinitand_srp/srp-mthca0-
ATA HDS722516VLAT80 V34O /dev/sda
GalaxyIB MyLUN
S Y S T E M I N T E G R A T I O N
2091 /dev/sdb
G U I D E
Section 2 Basic Setup