Logging Out - Rorke Data Galaxy Aurora Series Configuration And System Integration Manual

G A L A X Y ® A U R O U R A
If you wish to change the timezone, left-click on the Change timezone tab at
the top of the screen, then change the timezone, and left-click on the Save
button at the bottom.
On this screen, you can set the system time, hardware time, or both. Set the
time and/or date using the drop-downs. But here's the gist on the buttons.
Under system time is an Apply button. This is used to set the (software)
system time. It isn't a save button, because the software/system time isn't
saved anywhere – it is just an offset running from RAM. The Set system time
to hardware time button will set the system/software time to the current time
read from the hardware clock. In the lower table, is a Save button. This is used
to save the current hardware time. This is set in non-volitile memory inside the
array. The Set hardware time to system time button sets the hardware time to
the current system/software time.
To return to the NumaRAID GUI, expand the Hardware category on the left, if
it is not already, and left-click on NumaRAID GUI.

Logging Out

Although you do not have to log out of the array, it is better if you do, as the
logging in/out are logged by Webmin. To logout, simply left-click on Logout at
the bottom of the left menu.
142
C O N F I G U R A T I O N A N D S Y S T E M I N T E G R A T I O N
Section 5 Application / Technical Notes
G U I D E