Unpacking/Delivery; Safety; Symbols; General Instructions - Clarke FOCUS II MICRO RIDER 26D Instructions For Use Manual

UNPACKING/DELIVERY

To unpack the machine, carefully follow the instructions on the packing.
To move the machine manually, see the Pushing/Towing The Machine paragraph.
Upon delivery carefully check that the machine and its packing have not been damaged during transportation. In case of visible
damages, keep the packing and have it checked by the carrier that delivered it. Call the carrier immediately to complete a damage
claim.
Check that the machine is equipped with the following features:
– Technical documents:
•
Scrubber-dryer User Manual with Spare Parts List
•
Battery Charger Manual
– 2 lamellar fuses
– 1 battery charger spare connector
– 2 shims for 6V battery housing

SAFETY

The following symbols indicate potentially dangerous situations. Always read this information carefully and take all necessary
precautions to safeguard people and property.
The operator's cooperation is essential in order to prevent injury. No accident prevention program is effective without the total
cooperation of the person responsible for the machine operation. Most of the accidents that may occur, are caused by failure to
comply with the simplest rules for exercising prudence. A careful and prudent operator is the best guarantee against accidents and
is essential for successful completion of any accident prevention program.

SYMBOLS

DANGER!
It indicates a dangerous situation with risk of death for the operator.
WARNING!
It indicates a potential risk of injury for people or damage to objects.
CAUTION!
It indicates a caution or a remark related to important or useful functions. Pay careful attention to the
paragraphs marked by this symbol.
NOTE
It indicates a remark related to important or useful functions.
CONSULTATION
It indicates the necessity to refer to the User Manual before performing any procedure.

GENERAL INSTRUCTIONS

Specific warnings and cautions to inform about potential damages to people and machine are shown below.
DANGER!
– Before performing any maintenance, repair, cleaning or replacement procedure disconnect the battery
connector and remove the ignition key.
– This machine must be used by properly trained operators only.
Keep the battery away from sparks, flames and incandescent material. During the normal operation
–
explosive gases are released.
– Do not wear jewerly when working near electrical components.
– Do not work under the lifted machine without supporting it with safety stands.
Do not operate the machine near toxic, dangerous, flammable and/or explosive powders, liquids or vapors:
–
This machine is not suitable for collecting dangerous powders.
– Battery charging produces highly explosive hydrogen gas. Keep the tank assembly open during battery
charging and perform this procedure in well-ventilated areas and away from naked flames.
Operator's Manual - FOCUS II Micro Rider
ENGLISH
3