Sony PDW-700 Operation Manual page 193

Salvage NG! Salvage processing failed.
For details, see "Handling of discs
when recording does not end
normally (salvage function)" on
page 69.
Salvage The loaded disc cannot be
XXXX salvaged by this unit. The
"XXXX" in the message is a code
for XDCAM devices that can
salvage the disc. Refer to the list
of device codes (see page 70) and
salvage the disc using one of the
indicated devices.
REC INHI.! The Write Inhibit tab of the disc is
in the recording disabled position,
or salvage processing needs to be
done on the loaded disc. Set the
tab to the recording enabled
position. Or eject the disc, insert it
again, and perform salvage
processing.
1080/50i The loaded disc has a different
1080/25P recording format. Exchange the
1080/59.94i disc, or change the recording
format.
Index File! There is an unsupported index file
on the disc to which you are trying
to record. Exchange or format the
disc.
File System There is an unsupported file
system on the disc to which you
are trying to record. Exchange or
format the disc.
ILL. PLAY! An A/V phase error occurred
during playback. Stop the disc.
Lid Closed! The lid of the disc compartment
does not open. Check the lid.
Lid Open! The lid of the disc compartment is
not closed. Close it securely.
No Clip! There are no clips recorded on the
disc. Exchange for a recorded
disc.
No Disc! There is no disc loaded. Insert a
disc and try the operation again.
STOP ONCE! The operation is not possible
REC mode! while the disc is being played or
recorded. Stop the disc.
Loading! An operation was attempted while
Unloading! a disc was loading or unloading.
Wait for the disc to finish loading
or unloading and try again.
Disc Top! The operation is not possible
Disc End! because the disc is at the top or
end.
Formatting! The disc is being automatically
formatted. Wait until the format
ends.
Recording The unit is writing to the file
system. Wait until writing
finishes.
No EM Space Essence marks cannot be inserted.
EM Full! For details, see "Recording
essence marks" on page 75.
SB CLP mode An essence mark operation was
attempted while the SUB CLIP
indicator was lit. Press the SUB
CLIP/DISC MENU button to turn
the indicator off and try again.
No SEL List No clip list is selected. Create a
new clip list, or load a clip list
from the disc.
No List! There is no clip list. Create a clip
list.
No SUB Clip There are no sub clips in the clip
list. Register a sub clip, or load
another clip list.
SUB Clip NG The In and Out point positions are
invalid. Set correct In and Out
points.
MAX# SB The total number of sub clips is
CLP over the upper limit (300).
CL OVER The total duration of sub clips in
DUR the current clip list is over the
upper limit (24 hours).
FAN Stopped The main unit or drive fan has
DR-FAN Stop stopped. Avoid use under high
temperatures, turn off the power,
and contact a Sony service
representative.
NVRAM NG! An error was detected while
accessing internal memory. Power
the unit off and contact a Sony
service representative.
Update Err! A firmware update failed. Power
the unit off and contact a Sony
service representative.
Operation Warnings 193