Sony PDW-700 Operation Manual page 126

No. Page
06 AUDIO-1
07 AUDIO-2
126 Menu List
Item Settings
FRONT MIC MONO/STREO Input mode selection for front microphone.
SELECT
AUDIO CH3/4 CH1/2/SW
MODE
REAR XLR OFF/ON
AUTO
FRONT MIC REF –60dB/–50dB/–
40dB
REAR MIC REF –60dB/–50dB/–
40dB
MIN ALARM OFF/SET
VOL
SP ATT LEVEL OFF/3dB/6dB/
9dB
HEADPHONE MONO/STREO Selects whether to make the rear earphone
OUT
AU REF LEVEL –20dB/–18dB/–
16dB/–12dB/
EBUL
AU REF OUT 0dB/+4dB/–
3dB/EBUL
AU CH12 AGC MONO/STREO Selects whether to perform automatic input level
MODE
AU CH34 AGC MONO/STREO/
MODE OFF
AU AGC SPEC –6dB/–9dB/
–12dB/–15dB/
–17dB
AU LIMITER OFF/–6dB/
MODE –9dB/–12dB/
–15dB/–17dB
AU OUT OFF/ON
LIMITER
Description
Selects the sources to be recorded to channels CH-
3/4.
CH1/2: Same sources as CH-1/2.
SW: Signals selected by the AUDIO IN CH-3/CH-4
switches.
Turns the XLR connection automatic detection on
or off.
Sets the reference level of the front microphone.
Sets the reference level when the AUDIO IN CH1
connector is set to MIC.
Volume of the monitor speaker alarm tone when it
is turned all the way down.
OFF: Almost inaudible.
SET: Faintly audible.
Lowers the volume of the monitor speaker. Has no
effect on earphone volume.
monaural or stereo.
Sets the output level of the 1 kHz test signal.
Sets the output reference level.
adjustment of analog audio signals to be recorded
on channels 1 and 2 independently for each
channel, or in stereo mode.
Selects whether to perform automatic input level
adjustment of analog audio signals to be recorded
on channels 3 and 4 independently for each
channel, or in stereo mode, or not at all (OFF).
AGC saturation level setting.
For manual audio input level adjustment, selects the
limiter saturation level for loud input signals.
Turns the audio output limiter on or off.