Standoff Spacer Removal; Final Installation; Door Replacement - Viking 7 Series Installation Manual

Installation

Standoff Spacer Removal

DANGER
FIRE HAZARD
Backguards come standard with
standoff spacers which provide a barrier
between back of range and rear wall.
These must be in place for adequate
ventilation. Standoff spacers can only be
removed if range is installed against a
Non-Combustible wall.

Final Installation

1
Slide range into place. Be sure
wall anit-tip bracket slides into the anit-tip opening
and floor anti-tip hook and bracket are engaged.
2
Burner heads and bases are packed in cardboard top pack with
the grates. Place burner bases on top of the burner flanges and
burner heads on top of the burner base. Place burner grate on
top of grate support.
24
1a
3
" " "
3 / 8 3 / 8 3 / 8
) ) )
c m c m c m
9 5 9 5 9 5
( 0 . ( 0 . ( 0 .
Check that unit is level side to side
and front to back. The side trim must be 3/8" (0.95 cm)
above countertop. If unit is not level repeat Steps 5-7
of "Leveling/Adjustments/Alignment" section.
Installation

Door Replacement

1
Reattach door to range.
3
Close door.
25
2
1
1
Open door completely. Fold latches forward until
locked in place.