General Information; Installation; Door Removal - Viking 7 Series Installation Manual

General Information

READ AND FOLLOW ALL WARNING Moving, Handling, and Unpacking
AND CAUTION INFORMATION
Remove and discard all packing materials,
WHEN INSTALLING THIS APPLIANCE.
including cardboard and tape on the outside
and inside of the range.
• All openings in the wall behind the
appliance and in the floor under the Remove the burner grates, burner heads, and
appliance must be sealed. bases from the cardboard top packaging.
• DO NOT obstruct the flow of combustion DO NOT discard the
and ventilation air. metal brackets
supplied with the
CAUTION range. These are the
anti-tip devices and
Avoid any damage to oven vents. The
must be installed with
vents need to be unobstructed and open to
the unit. Refer to "Anti-
provide proper airflow for optimal oven
tip Device Installation"
performance.
section.
CAUTION
The cooling fan should be operating when
the unit is in operation. If you notice the
cooling fan is not operating or you observe
Some stainless steel parts may have a plastic
unusual or excessive noise coming from
protective wrap which must be peeled off.
the cooling fan, contact a Viking Authorized
The interior should be washed thoroughly
Service Center before continuing operation.
with hot, soapy water to remove film
Failure to do so can result in damage to
residues and any dust or debris before being
the oven or surrounding cabinets.
used, then rinsed and wiped dry. Solutions
stronger than soap and water are rarely
needed.
14

Installation

NOTICE
DO NOT use the handle or oven door
to lift the oven. Remove door before
installation to ensure that it is not used
to lift the unit. DO NOT lift or carry the
door by the handle.
Removing the door must be done by
your dealer, a qualified licensed plumber,
or certified gas installer.

Door Removal

1
Open door completely.
3
Slowly close until latches stop door.
15
2
Fold latches backward until locked in place
4
Lift door up and out.