Trigger Control; Triggerselector(Triggermode); Acquisition; Exposure - JAI AM-800GE User Manual

9.2. Trigger Control

9.2.1 TriggerSelector(TriggerMode)

This is the function to set the trigger operation. This will set how to control the output
and the exposure.
Acquisition Start
Acquisition End
Frame Start
JAI Acquisition Transfer Start

9.2.1.1 Acquisition

This is the trigger function to control the output. This controls AcquisitionStart and
AcquisitionEnd. A description of the configuration process is as follows:
 AcquisitionStart trigger: Set whether the capture start is to be controlled
TriggerMode On：
TriggerMode Off：
 AcquisitionEnd trigger:
TriggerMode On：
TriggerMode Off：
Note: Refer also to section 9.1.1

9.2.1.2 Exposure

These commands are used for setting the exposure control.
FrameStart is used for trigger input.
If ExposureMode is set to Timed or TriggerWidth except OFF, the combination of the
ExposureMode setting and FrameStart setting will determine the type of exposure
and whether triggering is OFF or ON.
The following table shows the combination and the operation.
AM-800GE / AB-800GE
Acquisition Set the capture start externally
Acquisition Set the capture stop externally
Trigger
Stream
externally or not.
After AcquisitionStart command is input, input the
signal selected by AcquisitionStart trigger as the trigger,
and make AcquisitionActive effective.
AcquisitionStart command is input. It makes
AcquisitionActive effective regardless of
AcquisitionStart trigger.
Set whether the end of the capture is to be controlled
externally or not.
While AcquisitionActive is effective, input the signal
selected by AcquisitionEnd as the trigger, and make
AcquisitionActive invalid.
AcquisitionStart command is input. It makes
AcquisitionActive invalid regardless of the trigger
source.
- 46 -
Set the frame start externally
Set the stream start externally