Led Light; Hints For Optimum Use - Black & Decker AS36LN User Manual

- If the clutch ratchets before the desired result is achieved, increase the collar setting
and continue tightening the screw. Repeat until you reach the correct setting. Use this
setting for the remaining screws.
Screwdriving applications
Torque range: low torque for small screws and high torque for large screws
Drilling/screwdriving
Select forward or reverse rotation using the forward/reverse slider (2).
◆
To switch the tool on, press the on/off switch (1).
◆
To switch the tool off, release the on/off switch (1).
◆
Screwdriving using the screw holder (fig. F1-F3)
The screw holder (7) can be used with 1" and 2" screwdriver bits. The screw holder cannot
be used with bit tip holder extensions.
Pull the screw holder (7) out the tool (fig. F1).
◆
Place the screw onto the screw holder (fig. F2).
◆
Push the screw holder towards the screw making sure the bit tip and the screw are fully
◆
engaged (fig. F3).
The screw is securely held to the screw holder with a magnet. The magnet does not work on
non-ferrous screws.
Drive the screw into the wall.
◆
When screwdriving, the screw holder retracts in order to allow the screw to be driven to its
required depth.
LED light
The LED light (5) is activated automatically when the trigger is depressed. The LED will also
illuminate when the trigger is depressed and the forward/reverse slider (2) is in the locked off
position (central position).
Hints for optimum use
ENGLISH
11