Black & Decker AS36LN User Manual page 9

Fig. A
1. On/off switch
2. Forward/reverse slider
3. Forward/reverse window
4. Bit holder
5. LED light
6. Mode selector / torque adjustment collar
7. Screw holder
8. Charger
9. Charging base
10. Charging indicator
11. Bit storage
Assembly
Fitting the charging base to the wall (fig. A & B)
The charging base (9) can be placed on a worktop or fitted to the wall to provide a
convenient storage and charging point for the tool. Screws and wall anchors are not
included.
Drive screws in the wall with the same distance apart as the slots (13) on the back of the
◆
charging base (9).
The distance between the slots must be 75 mm.
Slide the charging base over the screws to fit the base to the wall.
◆
Plug in the charger (8).
◆
Place the tool on the charging base making sure the charging indicator (10) lights up.
◆
Warning! Avoid damaging the power cord when mounting the charging base to the wall.
Fitting and removing a drill bit or a screwdriver bit (fig. C)
This tool uses screwdriver bits and drill bits with a 6.35 mm (1/4") hexagonal shank.
To fit a bit, insert the bit shaft into the bit holder (4).
◆
To remove a bit, pull the bit shaft out of the bit holder (4).
◆
ENGLISH