Table of Contents
Advertisement
o If you wish to switch on another zone whilst another is already in
use, simply press the ON/OFF button for the zone in question.
o IMPORTANT: WHEN MULTIPLE COOKING ZONES ARE
BEING USED. IF THE POWER OUTPUT GOES ABOVE A
CERTAIN LEVEL, THEN THE POWER OF PARTICULAR
ZONES MAY BE REDUCED. THIS DOES NOT INDICATE THAT
YOUR HOB IS FAULTY.
Turning off a zone
o Press the ON/OFF button of the zone that you wish
o If you have other zones that are still in use, then
o Before leaving the hob unattended, you must ensure that all of
the cooking zones are switched off. Press the minus button (3)
until the zone reaches zero.
o The zone will switch off immediately.
Residual heat indicator
o After a zone is switched off, the corresponding
o After 35 minutes, from the zone being switched off, the letter
"H" will go out.
o IMPORTANT: The residual heat indicator will disappear if your
mains supply is cut.
Locking the hob top
to switch off. After a few seconds the zone will
switch off.
they will not switch off.
cooking zone indicator will show a flashing letter
"H". This means that the zone has not been
switched off for over 35 minutes since last use.
Therefore it is more likely that the temperature of
the zone is still hot enough to cause injury.
o The whole hob top can be locked by
pressing the safety lock button (5) whilst
the appliance is turned on.
12
Advertisement
Table of Contents
