Table of Contents
Advertisement
5.13
Power outage Setting
The feature is preset to AUTO. You may also manually change the power fail back-
up setting.
Press MenU in idle mode to enter the main menu.
.
2.
Press
or
3.
Press OK and
4.
Press OK and
5.
Press OK to save your selection. You hear a confirmation tone.
Notes:
•
If OFF is selected, Power Fail Back-Up mode will not be enabled.
•
If AUTO is selected, the registered handset(s) will display Put on BS to power
outage for about
2 seconds, followed by PWR OUTAGE NO PICK UP when mains power
interruption occurs. Place the handset with sufficient battery power (usually not
lower than level 2) onto the main base unit to activate Power Fail Back-Up and
start up the base. If handset is already on the main base unit it will automatically
activate the Power Fail Back-Up mode (if it has sufficient battery power) and
start up the base. If AUTO is selected and handset is not returned to base unit
within approximately 2 minutes the handset will temporarily revert to Manual
mode to converse battery power.
•
If MANUAL is selected, the registered handset(s) will display TO PWR UP HOLD
OFF KEY when mains power interruption occurs. Press and hold
place the handset onto the main base unit to activate the Power Fail Back-Up
mode and start up the base.
to scroll to HS SETTINGS.
or
to scroll to POWER OUTAGE.
or
to select AUTO, MANUAL or OFF.
30
and then
Advertisement
Table of Contents
