Reset Operation; Vf Config - Panasonic BT-LH910G Operating Instructions Manual

RESET operation

1.
2.
[RESET]
MENU EXIT

VF CONFIG

VF CONTROL VF-CH
ALL-CH
REAR TALLY OFF
ON
ZEBRA OFF
ON
The priority sequence for GPI control and SERIAL is as follows: GPI > VF CONFIG > SERIAL.
YES
NO
SEL. ENTER ENTER
Description
Used to select the input line for the VF function of the monitor.
(VF function: tally lamps (red and green) lit, zebra displayed, !
displayed, aspect changed [SD])
<VF-CH>
<ALL-CH>
Used to allow control of the tally lamp on the rear of the monitor.
<OFF> Does not light.
<ON>
Used to set ZEBRA information in the camera.
<OFF> Sets the information to OFF.
<ON>
3.
This starts calibration.
[RESET]
MENU EXIT
xxxxxxxxx indicates that the following message
with the meaning listed below appears.
COMPLETE: Operation completed
4.
The underlined values are factory preset setting values.
Only enabled when the VF line is selected.
Enabled with all input lines.
Lights when TALLY control from a GPI/camera is ON.
Sets the information to ON.
xxxxxxxx
SEL. ENTER ENTER
37