Panasonic BT-LH910G Operating Instructions Manual page 31

SHARPNESS
MODE * 4
SHARPNESS H * 4
SHARPNESS V * 4
*
I-P MODE 5
MONO
*
ANAMO 6
SD ASPECT
*
SCAN 6
*
4
The following sharpness values are available and the settings for the selected input signal is displayed.
Adjustment status during selection appears at the bottom left of the screen.
1) VIDEO system input (VIDEO) (the factory defaults are SHARPNESS MODE: LOW and SHARPNESS
H/V: 0)
2) HD for any other input (the factory defaults are SHARPNESS MODE: HIGH and SHARPNESS H/V: 0).
3) SD for any other input (the factory defaults are SHARPNESS MODE: LOW and SHARPNESS H/V: 0).
*
5
To use the "SUB WINDOW" (page 42) function,
1) Change settings after exiting the "SUB WINDOW" function.
2) It is recommended to use "MODE2" for handling fast video.
*
6
"SCAN" changes are not reflected in Anamo size display.
IP mode
"MODE1" performs IP conversion using intra-frame interpolation.
This monitor suppresses the delay to within 1 field.
The factory default is "MODE1".
"MODE2" performs IP conversion using intra-field interpolation.
Since interpolation is performed inside each field, this mode is suitable for checking interlace status.
Description
HIGH Selects the width of outline correction edge.
LOW <HIGH> Narrow edge
<LOW>
0 - 30 Sets horizontal outline correction. The item display moves to
the lower part of the screen during adjustment.
0 - 30 Sets vertical outline correction. The item display moves to the
lower part of the screen during adjustment.
MODE2 Selects IP conversion mode. (see "IP mode" below.)
MODE1 <MODE2>
<MODE1>
OFF Switches between color and monochrome (MONO).
ON <OFF>
<ON>
*
OFF With an Anamo lens and HD-SDI input, the picture is resized
ON to Anamo magnification (the vertically enlarged signal can be
vertically compressed and corrected for display).
4:3 Sets the aspect ratio for SD signal input.
16:9 <4:3>
<16:9> 16:9 display
NORMAL Sets under-scan and normal display.
UNDER <NORMAL> Normal display
<UNDER>
Wide edge
Intra-field interpolation
Intra-frame interpolation
Color
Monochrome
When ON, the CHROMA setting of the picture adjusting knob
is fixed at 0.
4:3 display
Under-scan
31