Maintenance - Panasonic BT-LH910G Operating Instructions Manual

If for any reason an error occurs in this monitor, the LEDs above the picture adjusting knob flash at 1 second
intervals to inform of the error/warning.
1
1
*
1
Set the BATTERY REMAIN menu item of the SYSTEM CONFIG menu to ON.
*
2
The condition to display differs depending on the type and settings of the camera used in combination
with the unit. For details, see the instruction manual of the camera.

Maintenance

To clean the cabinet or surface of the liquid crystal protection panel, gently wipe with a soft, dry cloth.
If the surfaces are extremely dirty, use a soft cloth dipped in a weak detergent solution and then wrung-out
to clean the surfaces, then use a dry cloth to finish. Water or similar substances getting inside the monitor
can cause a malfunction.
Never use alcohol, thinner or benzene to clean this unit.
Doing so would cause the surface of the monitor to become discolored, and cause paint to peel.
Do not spray cleansers directly onto the monitor.
Water or similar substances getting inside the monitor can cause a malfunction.
! is displayed.
The voltage display flashes.
"END BATTERY" is displayed for
approximately 3 seconds before
the power supply switches OFF.
Check the setting values of the
camera.* 2
Replace with a fully charged battery.
Replace with a fully charged battery.
69