The Naming Screen - Elektron Analog Rytm Getting Started Manual

3 The current MACHINE in use will determine which SYNTH parameters will be available for Sound modulation. Quickly
press the first [PARAMETER] key, SYNTH, twice to bring forth a menu for MACHINE selection.
4 Browse through the MACHINE list using the [ARROW] keys [UP] and [DOWN]. Sample the MACHINE currently out-
lined by tapping the pad of the active track. Select the outlined MACHINE by pressing [YES/SAVE]. Exit without
switching MACHINE by pressing [NO/RELOAD].
5 Edit a track Sound by adjusting the parameters found on the PARAMETER pages. Access these pages by pressing one
of the five [PARAMETER] page keys. Use the DATA ENTRY knobs A-H to change the parameters.
SYNTH controls the oscillator tuning and other physical properties of the Sound.
SAMPLE controls the sample selection and settings.
FILTER controls the filter mode, cutoff frequency and envelope.
AMP controls the amplitude parameters.
LFO controls parameters for the LFO of the active track.
EDITING THE FX TRACK
1 Select the FX track for editing by pressing the [FX] key.
2 Set the volume level of the DELAY and REVERB parame-
ters of the FX track with the LEVEL knob.
3 Access the PARAMETER pages for the FX track by press-
ing one of the five [PARAMETER] page keys. Use the
DATA ENTRY knobs A-H to change the parameters.
DELAY controls the time, filter, volume et cetera of
the delay.
REVERB controls the pre-delay, filters and volume of the reverb.
DISTORTION controls the amount of distortion applied.
COMPRESSOR controls the threshold value, ratio and dry/wet mix of Sound compression.
LFO controls parameters for the FX track LFO.

THE NAMING SCREEN

The naming procedure is identical for the various naming situations that appear when kits, Sounds, patterns, songs or
projects are saved or renamed.
1 Use [ARROW] keys [LEFT] and [RIGHT] to navigate between the letters.
2 Press and hold [FUNCTION] to access the pop-up naming menu.
16